These designs are in 1:12 dollhouse scale with a few designs in 1:6 scale, but can be scaled larger or smaller with your printer. Each page has two small but deep and two larger, shallow boxes.
Preparation Print the designs on printer paper or light card. After printing, coat the designs with acrylic varnish or sealant if you wish. When the varnish is dry, cut the designs out along the outside lines and fold them to shape using a straight edge or bone folder.
Assembly
Make the box base
- Fold the sides and tabs the same way you did the tops and test fit that the box base fits into the lid. Trim if necessary.
- Glue the Base Together using the tabs and folding the inner sides and liners to the inside of the box.
- Glue the Box Liner in place on the bottom of the box.
